Separate names with a comma.
I'm looking at making a ramp for the back of my buzzard catcher, and while I'm at it figured a divider couldn't hurt as well. This brings a few...
Hi All, After a bit of a base for tuning our clutch now we're making the power we want. The setup is; 511ci Rodeck Chevy on alky BacMan...
What is the recommended torque figure for the wheel center bolts? (The fine pitch ones going into captives on the center) We're having our centers...
Hi All, Anyone else having any problems getting hold on Taylor? I need to get two sets of blower restraints re-tagged before our season starts,...
Has anyone got an email for AFT? I used to email Frank and Steve Brooks but I understand there's a new guy running the show now? Thanks Adam
What are people's thought on these two? From as far back as I can remember we've always used Clevite bearings in our motors, and on the whole...
Hi All (again!) After a bit of advise for lenco ratios here; 511ci Rodeck 481T, BacMan heads, Mooneyham 14/71 standard helix @40% over, Lenco...
Hi All, We run a Rodeck ally block BBC with BacMan heads in an altered, got a little concern over the oiling, when I lift and pull the chutes...
What size are the small 12 point bolts used on the clutch finger adjustment? AFT 11" aluminium clutch. Our socket has gone missing and obviously I...
We're running a Rodeck 481-T block with BacMan heads and the studs seem about half inch too short, not getting full engagement in the nuts, so...
How much and what type of fluid does a 9.5" Toploader take? It's a mk2 model if it makes any difference (no pump)
I'll start with the specs of what we're running: 125" altered around 2000lbs inc driver 511ci Rodeck Chevy on alky BacMan Heads 1471...
out of interest what spec are clutches heat treated to, what level of hardness does it have to meet in order to meet SFI spec
Who is the best to use, we've had Stilletto recommeneded just wondering what anyone else thinks. Will be on a 125" altered, blown alky Chevy
I'm in the process of designing new levers etc for our blown alky altered and was wondering what the preference is on fuel shutoff levers; mounted...
quick question, is the bolt pattern for trans to bellhousing the same for a Lenco and a B&J?
has anyone got dimensions for a big block chevy block and heads? thanks
what kind of downforce is required on the rear end of a 125" altered at 200mph?
Mickey Thompson ET Drag tyres, would you run with liners or just tubes? non beadlock wheels on a blown alky altered
What would be the optimal overdrive for peak efficiency on a black & white stripped 8/71 on alky? Obviously we want to spin it as fast as possible...