Separate names with a comma.
looking for thephone number for guy in Arizona that has blower starter parts. Thanks
looking for nice intake for Brad 5 heads
looking for the mag the box and coil
First one lasted 150 passes second lasted 20 not a set up issue but was a different manufacturer from first. Which company makes best gear set?
will a 5 amp hour battery hold a 20 amp load of a trans break solenoid for the few seconds you are using it before launch
this is for a blown alcohol application. I was thinking that the 2 step might be hard on valve train but I dont see to many cars with air...
can and clutch are Hemi bolt pattern trick titanium8 5/8 can has some boo boos trick wont recert older AFT titanium glide 3 or 4 disk clutch...
How can you tell the difference between a .156 and a .125 finger? I have some of each and they both look the same. What am I overlooking?
Number on back of cam is 2031A591 The Number 8952 is on the front 316-5 330-5 R12 is also...
Trying to see if the 7-4 and 5-3 cam swap on a BBC would be advantagous. If so what gain would I see.
Who would be the best person to send a set of Bac-Man heads to for service. And to also see if anymore flow can be squeezed out of them?
Been using steel floaters I have some bronze coated floaters. How will this change effe ct the setup. It is a glide clutch
I am working on a project and wondering wheather you can downshift and upshift a lencodrive during a run. Obviously not for dragracing but looking...
I have seen on blown cars that some have regular zoomie headers and I have seen some with a collector header. So it has me wondering which is...
its a 3 speed lenco drive with Tim McAmis air levers and pods w/ blanket. New Neal Chance bolt together stage 3 pro mod converterw/light weight...
I have been using Les Davenport's jetsize program for a few years without measuring vapor pressure or O2 percentage. Trying to get my tune up...
I have a Hilborn -4 and the high speed is plumbed in right at the pump. Would it be better to move it up to behind the barrel valve? It is an...
going to use a 4.250 crank and 4.500 bore I have a donovan BBC 11.2 deck block. I have a cubic inch limit of 575. I am wanting to stay at about...
what is good temp when heating oil to evaporate alcohol so it can be reused?
What are the advantages and disadvantages between each one?