Separate names with a comma.
I have a new Moroso pan with a -20 outlet. P&P pump has a -16 fitting. Question is -20 line with reducer at the pump or -16 line with reducer at pan?
Does anyone have a timken or other part # for a MW floater seal? MW part #76x6261 part # on seal tcm 185213 tm...
What effect would lowering the fuel temp for alcohol have on performance? of course all else being equal
Switching from dry sump to wet sump. Is a -16 line ok for a wet sump on the inlet side of the pump?
Just got a wet sump pan in a trade. It has a double -16 internal pickup, but my pump has a single -20, if there a special fitting for this set up?
Anyone use them in lieu of pills? Thoughts?
Hemi with a wet sump, most are running 10 - 14 quarts? Seems the capacity on a funny car pan is 8, do you even need a windage tray at that point?
Anyone seen these yet? Price is right at $1100 eachand they're 15.3 spec [IMG]
Anyone know where i can get stainless flanges for veney heads? Veney doesn't have them nor does SPD.
I talked with my motor guy and he says since I only run 1/8th mile, I'll be ok with wet sump. I asked, but he'd never done it, so i thought i'd...
I am selling my current car and moving up to promod. We run a dry sump now(kb block 526 screw hemi Plueger pump) and have zero oiling issues. A...
anyone know the weight diff between a kb stage 10 cast block and a brad billet block?
I've got one race left this season and am replacing a piston. My motor has moly rings in it, but the only thing i have is a stainless ring to put...
I've got a set of 2.5 veney heads. What is the normal spring height on these things? I'm at 2.1 int and 2.0 on exhaust. I'm looking at different...
Noel, could you call me about the springs i purchased this week? having a small issue thanks! 214-724-1056
I'm having some kind of oil leak in the plenum of my intake that I can't track down. I've attached a couple of pix, and have more on photobucket....
i run 2 batteries in series for 24 volt to go to the starter. i pull all the 12 v electronics off the first positive post to run the 12 volt...
Running 526 Veney 2.5 valve motor w/ 10.6 compression, mag 44, whipple screw making 43 lbs of boost. Currently running 27 degrees max, my motor...
Can anyone that has a bottled fresh air system please check their regulator for a manufacturer and part #? I am wanitng to make a system and have...
I have a regular gear puller but it will not work on the crank gear because it has a radius on the back side of the gear. Any body have a solution...