Separate names with a comma.
hi needing so used hemi parts kicking around hidden in the shop. Alky pistons in bore size 4.375 fr older alky fuel heads low deck block 3.750 to...
hi wanted to know if you can take studs and cut them down to fit a low deck Kb block was thinking doing the course end that fits in the block. Do...
Hi bud has dart billet hemi heads older fueler 190cc and using 4.5 stroke crank 6.86 rod length. Std deck block. He wsnts to run alky injected thx
Hi with out tearing them apart. Or with out and numbers or letters stamped on either trans. Thx
Hi if crank had spider cracks and the crank was ground down to ten under and spiders cracks gone. Would the crank handle a thousand hp? Thx
would anybody know if these block have oiling problems, if so what would a person need to do to correct it, running low hp blown deal 1200 hp in...
hi would anybody know what colour of stands I need for my .100 tall fuel heads. will be running them with my dick landry roller rockers. dont have...
hi do they make blower engine bearings in .030 to .040 for crank and rod, use will be 15 to 20 lbs boost 7000 rpm big block chevy. have a crower...
what is the weight of a bae billet block with sleeves thx
here is a link to the chevy build. http://nitroimage.proboards.com/index.cgi?action=display&board=GRD&thread=2259&page=1#12022
do u have to mic the bearing for its thickness, so it doesnt spin and spit out the rods. or mic the big end of the rods to make sure the bearing...
hi was wondering if you can drill out the rod pin hole to another size with aluminum rods? have good pistons in a 1.156 pin size, but my new rods...
hi what spec of pistons will I need for this combo, its a 10.200 rodeck alum 481 block, 4.5 stroke crank, 6.8 lenght rods. have dart alum 320 cc...
hi wanted to know where is the best place to buy mallory metal. needs to do 2 cranks with steel rods, so 6 to 8 pieces or can you buy a small...
hi would aluminum rods go stale so to say if you had them kicking around for a few years. also is there a special way they have to be stored and...
hi any 1 knows what sleeves interchange with, kb stage 4, 5, jp1 older, std deck blocks, also if any inter change with TFX blocks too thx
-------------------------------------------------------------------------------- anyboby have a hemi short deck manifold lying around colleting...
hi wanted to know can you use a eagle 4340 crank in a blown 1200 to 1400 hp hemi. was told clearances are not there. not sure why, is that because...
hi guys want to know the pros and cons of running gas vs alky on a blown 526 hemi witth either std or high helix 14-71 blower with bird catcher...
hi guys who would known what deck height this block would be. caps have numbers 539, on the back of the block serial number id 84-011. also need...