Separate names with a comma.
Wanted to Buy A/Fuel engine parts, looking for a nice billet short deck block, Cam, Brad 8 A/Fuel heads or similar, manifold and injector....
Where’s the best place to order a new rotating assembly from. Want to go to a different combo after junking my last block.
Looking for a 3.750” or 4” stroke Hemi crank std std with a clean mag. Anything around
Hi. I just bought a second hand V300SD logger and was wondering what do I have to do to be able to log fuel flow and clutch rpm? I have a flow...
I'm looking at using an 18 volt power tool battery with a dock to run the electrics in my car, powergrid, tacho, logger and lighting for other...
I'm trying to find some 5" centres steering arms that will fit the strange S3453 part number dragster steering arms. There's nothing listed on the...
Is there a formula for working out how much a tyre will grow in diameter through the top end of the track. Tyre is a MT P/N 3195, 35.0/15.0-16 on...
How much is too much castor for a 225" FED. I have a set of McKinney fuel car A-arms that I was looking at using but after I dummied them up on...
I'm building a new FED chassis and no where in the SFI spec does it mention the shoulder hoop height in relation to the drivers shoulder height....
Just wanting to get a SKF or National part number for the grease seals for Weld anglia spindle mount wheels to strange spindles.
What is the minimum required length between the engine plate and rear end centre line for easy removal/install of a 3 speed CS1 with 8 5/8" can.
I have 2 crower 10" pedal clutches one has rivets holding the facings on to the flywheel and donut and the other has the countersunk screws. Which...
Just wondering what sleeves will fit a JP1 block, would like to get a few spares. Bore is 4.310"
I have a set of old 10 bolt brad fuel heads on my engine. I've found some cheap AJ3 fuel heads. Are they interchangeable with each other. Do...