Separate names with a comma.
Yea So Steve where did the 5:38 come from " beats me !!!! "
Robert TF deal just noticed that they have different brand cranks mixture and measured the flange thickness to my surprise they were different.....
Trying to see if these used cranks are worth using with different thickness flanges?
Will still have the shifter manifold? If so I will take it.
Ed JP from MGM racing has great smoking deal on 10 " Molinari and Crap load of floaters and disk...
1.375 10 Spline 11 disks needed
Plus Floaters small stands 6 plus threes extra short little stands
Scott sent email I take the rings
Hey Will you every see any number for front engine car? should I target a 600-700 Axles speed. I am assuming the 800-850 is for a FC
Jake Sander runs at least 5 stage dry sump on his NFC Mr. Explosive.
off Front drive.
You can call him Snake Ent. 253 777 6143
Waterman also makes pump that is thinner than KB
Custom Floater is cert till 5-19 2019
Should cert just fine I also added cross shaft and fork for it
Hey guys will the sleeves in my New Century block come out like a BA TFX block with slap hammer?
Ti-Can Sold Chevy still available added cross shaft and fork
Anyone needing a hand at the Winter warm up in AZ 2018 let me know I am planning on wondering around pits.
602 206 nine six six nine
I have two 8/18 clutch cans for sale:
#1 Steel custom Floater Chevy 6.3 right side block starter Lenco pattern shaft below input No shaft or...
So do you guys just saw off a normal hat nozzel holder an screw it into cooling holes in rear of blowers or do they make a golden nozzel holder...
Can you swap out standard rotor to HighHelix in 6:71
I have a Kuhl mini retro
Can Lttilefield install HH rotor?