Separate names with a comma.
Do you guys take your rockers off to let the valve springs relax between weekends? For me putting the rockers on is only about a 15 minute job,...
Ok, I want to thank everybody on here for the input on my last few posts. We ran 5 passes at KCIR and the thrust bearing is just fine, no endplay...
OK here we go again. 1 pass 1/4 mile rear side of thrust bearing GONE copper compleatly gone. We linked the motor forward so no rearward movement...
We run a Wedge headed KB-5 block in a 3200 lb door car with a glide. We keep killing thrust bearings, only the rear surface, "crank wants to go...
Does anyone know if there are +.001 or .002 clearance hemi main bearings out there. Im trying to get a little more clearance in the mains and...
When I ran all NA stuff we always had better luck with the coated bearings, when I put my blower motor togeather I used the same coated bearings....
I went shopping for a converter and Im looking for info on bradco's stuff. He seems very sharp on converters and racing in general. I have a 10"...
I took my first blown alky ride ever this weekend and im hooked for sure. it went 8.409 @ 165.5 my second trip, we went up in smoke my first...
Ok here is my problem, when I get the idle set where I like it my throttle gets really sticky down around idle, as far as I can tell the vacuum...
Im new to blowers, I started my motor for the first time yesterday and everything was good. I run 8 hat nozzels and port nozzles, at an idle...
Just a simple question, what is the torque spec for a 1/2" L-19 flywheel bolt. I just have a feeling I have been under torquing them. Do you...
Just wanting to run a few things by you guys. 1 Im building a low boost alky 28% over 8-71, 12 to 1 static comp, 572" mopar, Im wondering...
I just wanted to get some opinions. Im building a blown alky 572" Mopar wedge, I know its kinda big but its what I have, here is my combo....
