Separate names with a comma.
On my system, I've got a flow meter after the barrel valve, then a Y with separate lines to the hat and port distribution blocks. Why don't we...
I am getting ready to go back together with the engine I recently purchased, and thought this might be an opportunity to create a really useful...
This dragster is my first parachute car. I have changed the layout of the handles to suit me better, and was test-firing the chutes today, when...
I called them today needing one upper and lower main bearing. I have a set of M bearings in the engine that still look brand new and want to run...
Will, I was reading an old post of yours a while back in which you mentioned "fingernail" testing bearings. I am assuming you meant if it has...
The mains in my KB10 are Clevite MB3248M. Are they discontinued or something? I've searched all over the place on the internet and can't find...
A guy today said KB never sent a hemi block out with aluminum mains, but my Stage 10 has em. Doesn't sound right, but I thought I'd ask the...
What kind of RPM are you guys running on fuel heads? Still new to all of this, and am trying to get some context. I understand that the pistons...
Hey guys, I need opinions on where to set my timing to start tuning. Obviously I want to start a little low, and bring it in as we tune, but I...
I was searching the forum for info on the idle poppet, and came across a post by Mike Canter that discussed how minor changes to the leakdown...
I just weighed my new Brooks rods in preparation for balancing. I show a high-to-low of 1.7 grams. I haven't weighed the pistons yet, but assume...
In the rule book it says supercharged big block dragsters are 1800 minimum, but doesn't say how. Is it with driver? Is it at the end of the...
I am looking at possibly fabbing up a new set of wing struts and braces for my dragster, and because of the insane size of round tube required by...
I can find the dimplers for sheet metal, but I want to fasten a small 1/8" aluminum plate with them, and need a countersink I can use in my drill...
I don't have the spec, and need to know what the main member material size is for the cage on a 6.0 cert dragster. Is it 1.5 x .065 in moly?...
I am not sure how to set up my master shut off based on NHRA rules. They say I can only have one shutoff, but I have two electrical systems and...
I pulled my cam and got the following numbers off the end. They are hand engraved. The cam is an Erson, and I have sent them an email, but it...
Having the right tool made all the difference. Came off first try, fairly easy actually. Lots of metal transfer. Lumps on crank snout, keyways...
Is there a common way to shut down one of these blown alcohol engines after a run? Never done it yet, don't want to guess. -Scouder
Went out this afternoon all excited to get all the junk off the front of the engine and get the cam out so I can see what I've got. All went well...
