Separate names with a comma.
Hemi with angled idler. First time setting the belt tension. How is it done? Thanks for any help. -Brian
Still wiring the dragster, almost done now. I got my points box wired to the coil, and also to the cable kill switch. I decided it would be good...
Does the shielded trigger wire need to be kept away from the two wires that run from the points box to the coil, or does the shielding protect it?...
Is it typical to put washers under the bolt heads that hold the torque converter to the flexplate? Are the bolts something specific, or can I...
I have a KB oil pump on my Hemi, and a remote System 1 filter. When I disassembled the engine I marked the position of the lines so I could get...
Is the bolt pattern on my KB Stage 10 block, which has 9 bolt holes, different from the stock 426 hemi/440/383? The reason I ask, is I ordered...
I twisted off a 5/16 course allen head bolt in my chassis today. I thought I would just drill it out and re-tap the hole, but so far it just...
Mag KB fuel head manifold to head nut and roots blower stud nut. I did a search on both, nothing. Thanks for any help. -Brian
I am putting a new cage on my TD so I can fit under it, and am having a problem cutting the tubing with my Ace Hardware hole saws. They have...
I currently have a TCI adapter, it's about .510 thick. I would buy another TCI but it seems everybody is out of stock right now. Is there...
I have a Jegs round 15 lb tire gauge, and I need to know how it works. Does it measure an absolute pressure, against a spring, for example, or...
What do you guys recommend for a blown alcohol dragster? I think all that's required is a -15. Do you guys go -15 or -20? Boots? Overboots?...
I just measured my rockers and it looks like my intakes are about 1.65 and my exhausts look like 1.5. Are these among the ratios that were...
My strange floaters use a 4-prong axle nut. Where do you get this tool? Is it proprietary through Strange, or is there some other tool that will...
What's a good range for cam end play? I thought this would be an easy one to find here on the forum, but I searched my *ss off and couldn't find...
I just looked at an old performance book that showed the top ring gap right in the middle of the thrust area. I was going to install mine away...
This may seem like a silly question, but all these years I never thought about it. When a bearing is torqued into the cap, there is a certain...
What are the Hemi sizes? What was the stock size? Thanks. -Scouder
When I put in my last set of new rods, the manufacturer said to torque the bolts, then release them, 5 times for the final torque. On my new...
I will be setting my crank back in the block in the next couple of days, and would like some input on the procedure for sealing up the rear main...
