Separate names with a comma.
Most mag drives are unstable and cause the timing to fluctuate. This could be as much as plus or minus 1 degree meaning you could have up to...
You need a data recorder to see where you start making boost and I bet it is not at 3500 rpm. That is going to hold the engine rpm back so no power
Somebody else chime in here but with that 1.76 gear you would want a higher stall like 5000-6000 stall even if you were staging at 3500 rpm so the...
What transmission because that's not a very high stall.
So you have a water block? Most of us on Two Steps are using a lot stronger crank than that. You might get away with it with a lower launch rpm
That's a hard decision to make. No doubt it will increase your performance but don't know what block or crank you are using. It is tough on cranks.
The only we car about is EGT temps and having the plugs look correct.
Mike what you are saying about your plugs indicates you are real rich maybe 15-20 main jet sizes. This is another reason the motor will not rpm....
Mike what do your plugs look like after a run? A single run on new plugs.
Al Billes? He has a dyno that will handle blown alky motors but which one it is I don't know.
200 psi when? What rpm? 9000, 10000 or what. So as a reference what is you fuel pressure at 8000 in first gear?
Try gapping your plugs at .015" and see what happens. That what we all run with the ProMag 44
Is this car driven on a track or the street. What do you have your plugs gapped at? It is hard to tell if that is an ignition problem or a fuel...
That is all my understanding. Yes to all the above.
BAE is good and so is AJPE. If you have money to burn the best is the billet one from Noonan Racing (NRE).
Junior dragster maybe?
I have tried turning the nozzles up but didn't see any difference. That was the thing to do about ten years ago. It came and went. For myself I...
250 microns is .0098". Bet you don't have any jets that small.
The way I look it it the holes in that mesh of the filter are way smaller than the orifice of any jets being used. It only takes a second to check it
Get yourself one of these stainless steel barrel valve inlet screens. If they reduce flow then it is so little it makes no difference. Just check...
