Preferred port can location & pressure....

Discussion in 'PSI Superchargers Tech Questions' started by GregM784, Apr 26, 2018.

  1. GregM784

    GregM784 Member

    Joined:
    Aug 24, 2008
    Messages:
    915
    Likes Received:
    13
    In my mind, i see it better that the port check be located at the dist block so the feed line stays full.

    Also, my idle check is 5.5#. port check should be............? 10?

    I leave at 5,000 RPM, or 45# of fuel pressure.

    This is a blown sbc that runs NE1 (7.60)
    8.91 gpm pump, 4 x .041 in hat, 8 x .035 in manifold .100 main, .050 in highspeed @ 70#
     
    #1
    GregM784, Apr 26, 2018
    Riggs2 likes this.
  2. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    The idle check system the fuel pressure during idle. If it idles ok at what it is set at then leave it alone. Port checks are normally set so that the port nozzles are not on at idle so that depends on what your fuel pressure past the BV at idle
     
    #2
    Mike Canter, Apr 26, 2018

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM