MBR, B&J, MSD, Coan, Meziere, Littlefield, RPM, ect.

Discussion in 'Noonan Classifieds' started by GumBGone, Feb 3, 2018.

  1. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
    MBR – Minor Bros Racing 471 Hemi. Billet block and heads. All new accept block, heads, timing cover 9 partial runs ago. 0 runs after disassembly and new rod and main bearings. Manifold to pan, 2 pans. Barnes oil pump. 2 sets of double wall zoomies with egt bungs for funny car and door car.. Bryant crank, GRP rods, Morel lifters, Aries pistons, Victory valve gear. Spare new pistons, rings, bearings, valves, valve cover, timing cover and oil pan gaskets included. $26,000

    Littlefield 14-71 Hi-Helix $2600

    1 – B&J 3 speeds mag cased, single sprag with choice of gear sets, extra gear selections, spare sprags and gear sets. Extras now for sale.

    Quick drive, works great., with extra clutches and steels $3200 SOLD


    Coan Billet aluminum Blown Alky bolt together converter with extra stator – titanium bolt upgrade fresh $2900 - $4500 new. Very low runs.

    10 inch Blown Alky weld together 5600 stall converter fresh $800

    Meziere Hemi starter with 24 volt solenoid VGC $425

    Meziere Billet Flywheel (flexplate) $475

    MSD Promag 44 low use with good used cap, rotor and wires. 1 each new cap and rotor. $2050

    2 Points boxes with rev limiters – one as new, one tested at MSD good. Red and black coils. $600 ea

    Waterman pump with .800 gears – new steel body. Shut off, pump loop, Wizard fuel log. $1350

    DMPE 3 hole funny car carbon fiber injector hat, repaired, good condition and smooth operating $1800

    5 rails of nozzles 200+, 1 block of pills. $3 nozzles, $2.50 bypass pills. free block with purchase SOLD

    RPM Performance Product data logger. Very good condition. SOLD

    ADDED:

    2 K barrel valves with check valves, loop, filter, hoses and fittings, blown alky $200

    2 110 Enderle Pumps, very good condition $375

    Shut off valve

    Fuel distribution blocks with lines, port and hat

    Electric over air shifter for B&J or Lenco. $500 obo, $800 new

    NIB push pull shift buttons from B&J, works on Lenco also $110 ea

    8mm pulleys - 45 GT never ran, 44GT used, 63GT Center flange used, 61GT new never ran, all black anodized.

    CO2 bottles and clamps

    Air throttle and cable, set up to adjust launch rpm. Air throttles and controllers. MSD 2 and 3 steps.

    Couplers and drive shafts - new and used

    Racepak splt collar 1.875" PN: 800-cl-2m-187 unopened package

    DJ Adjustable Nomex covered blower restraint straps New in the package, dated May 2017 paid $138 now $60

    Carbon - blue belt 1 new 1 low run with a 6-71. 8mmGT 1440-75


    Prices do not include shipping and are best offer.


    Scott

    541-480-4505

    spauto@bendcable.com
     
    #1
    Last edited: Jun 5, 2018
  2. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
  3. aafa760

    aafa760 Member

    Joined:
    Jul 13, 2010
    Messages:
    102
    Likes Received:
    4
    Scott how new is the RPM setup? Will it work on Blown Alky car or was it for A-fuel?
     
    #3
  4. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
    I used it on a blown alcohol car - boost sensor. I started out with the minimum then sent it in and had it upgraded to add the flow meter and 2nd fuel pressure. There is lots of capacity left for other sensors.
     
    #4
  5. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
    Hey Spike, you email to me bounces back saying your folder is full. Yes I have the starter and flywheel
    Scott
     
    #5
  6. Nickdroit

    Nickdroit New Member

    Joined:
    Mar 31, 2018
    Messages:
    2
    Likes Received:
    0
    #6
  7. TWISTED

    TWISTED New Member

    Joined:
    Apr 6, 2018
    Messages:
    5
    Likes Received:
    0
     
    #7
  8. TWISTED

    TWISTED New Member

    Joined:
    Apr 6, 2018
    Messages:
    5
    Likes Received:
    0
    Whats the price for the newer,MSD #81473, MSD points box with rev limiter.
     
    #8
  9. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
  10. GTPerf

    GTPerf Member

    Joined:
    Oct 22, 2006
    Messages:
    204
    Likes Received:
    5
    does the Quick drive have a bell housing?
     
    #10
  11. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
    Sorry, SOLD

    MORE Added to the list
     
    #11
    Last edited: Apr 19, 2018
  12. GumBGone

    GumBGone Member

    Joined:
    Feb 11, 2007
    Messages:
    158
    Likes Received:
    0
    To the top, thanks
     
    #12
  13. dragster156

    dragster156 Member

    Joined:
    May 31, 2012
    Messages:
    143
    Likes Received:
    4
    Specs on conv

    Size
    Pump
    Stator

    Thanks
     
    #13

Share This Page