Fiberglass bodywork

Discussion in 'PSI Superchargers Tech Questions' started by Iron Crisis, Aug 1, 2017.

  1. Iron Crisis

    Iron Crisis New Member

    Joined:
    Jun 12, 2017
    Messages:
    15
    Likes Received:
    0
    Hopefully I'm not too far off topic but I'd like to know if anyone has ever stretched a fiberglass body. I just bought an older Topolino body. It will be too short for the chassis that I'm building so I plan on stretching the nose section 6" or so. I don't know how I'm supposed to compensate for the front section getting narrower when I section it. If anyone has any advice, I would greatly appreciate it.

    Thanks!
     
    #1
  2. jay70cuda

    jay70cuda Well-Known Member

    Joined:
    Sep 30, 2009
    Messages:
    1,139
    Likes Received:
    35
    Pics might help. I've done tons of glass work.
     
    #2
  3. Iron Crisis

    Iron Crisis New Member

    Joined:
    Jun 12, 2017
    Messages:
    15
    Likes Received:
    0
    Here's the body. I want to stretch the nose of it. It narrows as it goes towards the grille section. I'm not sure how to compensate for that.
     

    Attached Files:

    #3
  4. Iron Crisis

    Iron Crisis New Member

    Joined:
    Jun 12, 2017
    Messages:
    15
    Likes Received:
    0
    Any help would be appreciated
     
    #4
  5. comp altered 632

    comp altered 632 New Member

    Joined:
    Jan 8, 2016
    Messages:
    20
    Likes Received:
    2
    I had to modify my 27 t body.
    cut up body .
    Fit the body parts where you want them then fill the gaps with flexible sheet material. Finish with glass and filler.
    This is now your finished buck .
    Use this to lay up your new one mold..
    Then make body .
     
    #5
  6. hotrod200

    hotrod200 Member

    Joined:
    Mar 30, 2011
    Messages:
    118
    Likes Received:
    1
    I have done a lot of jobs like that, where are you located?
    I'm in so cal but can give you some a few ideas or options how to go about it.
     
    #6
  7. Aussiebattlr

    Aussiebattlr Member

    Joined:
    May 24, 2016
    Messages:
    58
    Likes Received:
    2
    A good friend of mine did a similar job, he cut the body where he wanted to stretch, then he cut the front piece down the middle, then made it to suit, and took about 3/4 of an inch out of the middle at the back to compensate for it getting narrower.. Looked the treat!
     
    #7

Share This Page