Late Model MBR Engines for sale = the good stuff not the old stuff

Discussion in 'Noonan Classifieds' started by clint thompson, Jun 7, 2017.

  1. clint thompson

    Joined:
    Jan 15, 2004
    Messages:
    633
    Likes Received:
    4
    Don't be fooled. all "MBR" parts are not the same. Don't fall for some cheap, outdated, worn out old stuff and then wonder why you aren't competitive. Get the good current stuff right here and save some dough. I am not quitting TAFC. I am switching to Noonan engines because I work for them now.

    engine 1

    AJ billet block, 10.7 deck ht. NEW STYLE HEADS, NEW STYLE BILLET INTAKE Billet black anodized valve covers, billet black anodized front cover with barnes oil pump and RCD clamp on mag drive, center flange RCD hub and degree ring. MBR billet fuel pump extension, RCD idler bracket and pulley, and Dan Olsen oil pan. will offer with dry sump pump and pan or wet sump. MBR aluminum roller rockers. This engine has two runs since BRAND NEW : HEADS, crane tool steel cam, jesel 1" lifters, PAC springs, Victory1 titanium valves, retainers, keepers and locks, Bryant 4.125 crankshaft and Arias (Bob Miner) 4.500" pistons, GRP rods. The block itself has 68 total runs and had new main caps and sleeves installed when assembled. This combination has run in the 5.40's in TAFC and is a practically new engine. We put two runs on it, serviced it, and put it under the bench. was $39,000. NOW REDUCED TO $36,000

    engine 2

    AJ billet block, 10.7 deck ht. NEW STYLE HEADS, Billet black anodized valve covers, billet black anodized front cover with barnes oil pump and RCD clamp on mag drive, center flange RCD hub and degree ring. MBR billet fuel pump extension, RCD idler bracket and pulley, and Dan Olsen oil pan. will offer with dry sump pump and pan or wet sump. MBR aluminum roller rockers. This engine has ZERO RUNS since NEW : Bryant 4.125 crankshaft, GRP rods, CP pistons, Morel 1" lifters, PAC springs, Victory1 titanium valves, retainers, keepers and locks, rings and bearings. The block has been fitted with NEW sleeves and the cylinder heads have a fresh valve job with new parts. Same combo in both engines. This engine has new magnesium manifold. was $34,000 NOW REDUCED TO $32,000




    prices plus shipping.

    Contact Clint Thompson at 541-944-4141 for details or email at ct6345@aol.com
     
    #1
    Last edited: Jun 22, 2017
  2. clint thompson

    Joined:
    Jan 15, 2004
    Messages:
    633
    Likes Received:
    4
    THESE ARE GREAT ENGINES. LATE MODEL MBR STUFF. FULLY FRESH, RACE READY , AND COMPETITIVE. SCREW BLOWER TUNE UP AVAILABLE. NEED TO MOVE.
     
    #2

Share This Page