Who builds the best diff housing?

Discussion in 'PSI Superchargers Tech Questions' started by Cdn526, Nov 26, 2016.

  1. Cdn526

    Cdn526 Member

    Joined:
    Dec 12, 2006
    Messages:
    535
    Likes Received:
    5
    I have to replace the center housing on my TD, re-using my Strange 9.5 pumpkin.
    I have the spindles/hubs/etc, and can make the spindle bells to fit anything.
    So I need a fabricated center housing that's approx. 16" wide (I'm back-halving the rail so I can build to suit), and can handle 2500 hp.
    I did see that M/W has one (p/n 90100) that seems ideal, but not sure if it's strong enough, or whether a 9.5" fits inside it.
    Any suggestions or recommendations?
    Would kinda like a fab'd one out of moly.
    Thanks!
    Clif
    cb@nitrobull.ca
     
    #1
  2. a/fd slngsht

    a/fd slngsht Member

    Joined:
    Dec 2, 2004
    Messages:
    314
    Likes Received:
    3
    Hey Clif .. call mittler brothers ask for Ray Sauer... tell him I sent you... they make an incredible fab housing I have one in my front motor a/fuel car....

    Neil and parks also... another top notch fab housing..... good luck... Mike
     
    #2
  3. bandit496

    bandit496 Member

    Joined:
    May 25, 2010
    Messages:
    174
    Likes Received:
    5
    Advanced Chassis in Antwerp, OH can make what you want if they haven't already done one. JW
     
    #3
  4. Cdn526

    Cdn526 Member

    Joined:
    Dec 12, 2006
    Messages:
    535
    Likes Received:
    5
    Thanks fellas, I'll check them out.
    Clif
     
    #4
  5. Bob Meyer

    Bob Meyer Comp Eliminator

    Joined:
    May 13, 2003
    Messages:
    763
    Likes Received:
    36
    Clif; We build a drop-out 4130 center case that replaces early light weight 9" or 10.5" Chrisman. Uses 14.375" mount system for Chrisman plates, spindles, hubs and live axle. Also available billet case for 4" spool that uses 10" generated gear. 619-440-7701
     
    #5

Share This Page